Release Notes

[1.1.3] - 2020-11-27

Added

  • [66564],[67752] bsp: add spidev0.0 for ethernet switch and spidev0.1 for hsm element
  • [66061],[67902] hw23: added gnss-mgr

Changed

  • [65220] boottime: improved boot time by:
    • [67739] Reduce priority of bootloader-config
    • [67742] Power WWAN modem directly from kernel; Increase priority of WWAN service
  • [60060],[69098] hw23: disabled bootloader-config service as it is currently not used and to prevent failure at start-up
  • [65320],[67904] gnss: allow configuration of the refresh rate up to 10Hz

Fixed

  • [66530] hw26: fixed pycurl version mismatch
  • [68069] bblayer.conf: fix wrong BBFILE_DYNAMIC typo for meta-ublox-module
  • [68024] fct and lava image: fix missing mac80211 kernel module
  • [68021] hw23: wlan layer breaks the support for this HW
  • [66059],[68083] firmwares: Make compatible with IMX devices (VCU2)
  • [69147] build-system: Fix rebuilt of kernel and kernel licenses errors

Known Issues:

  • [65740] gnss-mgr: very rarely service does not start
  • gnss-mgr: navigation does not immediately resume after a system restart in a 2D dead reckoning situation without GNSS reception.
    • navigation only resumes once GNSS reception is possible again
    • typical scenario is parking a vehicle in an underground parking lot/parking lot with no GNSS reception
  • ostree: update may fail if there is not enough space on root partition
    • workaround: free space used by log files
    • # journalctl –rotate
    • # journalctl –vacuum-time 1s
  • [63349] ostree: when using a partition overlay, some files may remain over update and create incompatibilities with new version
  • [65420] tibluetooth: Fix service stop